CARRICELL
Operating Instructions:

1. Use the flexicord provided to plug your Carricell into a vehicle accessory
(lighter) socket, transformer or battery charger (with the accessory socket.)

2. The left-hand indicator light comes on when the Carricell is connected to
power. The right hand light shows the heating elements are on and will
switch off when the unit is up to temperature: 32 to 340C on the digital
strip thermometer beneath the foam tray.

3. Preheat your Carricell for approximately l5 minutes before use. When the correct temperature is reached, transfer queen cells into the foam tray

4. Queen cells are fragile and should be handled with care at all times. Avoid jolting or bouncing your Carricell.

5. When the unit is unplugged the operator will need to ensure cells are not exposed to extreme changes in temperature. In mild-warm weather, the unit could be left unplugged for short periods. In cold conditions the unit should be unplugged only briefly and the lid kept closed as much as possible. In hot sunshine care must be taken to avoid overheating. Keep your Carricell shaded and never leave cells in direct sunlight. Temperature must not exceed 34 degrees Celsius

Notes:
Accessory sockets are easily filled to most vehicles or tractors.

The foam tray can be removed and placed in a larger incubator or hot water cupboard overnight. Monitor the temperature and ensure it does not exceed 34 degrees Celsius.

Added humidity is not normally necessary for short term incubating of 10-day cells but if desired, lightly spray the underneath of the foam with water.

The Carricell will operate on 12 - 24 volts AC or DC power. It is polarity protected so the unit can be used on vehicles with positive and negative earthed batteries.
For connection to a battery charger, cut wires to battery clips and connect to accessory socket using electrical connector supplied. Battery clips may be rejoined using the same connector.
For connection to a transformer, the output voltage must be between 12 - 24 volts. Connect output to the accessory socket using connector supplied. The rating of the transformer must be 50 volt amps or more. Before any connections are made to battery charger or transformer, ensure mains power is switched off The power consumption of the Carricell is minimal, using only 1.8 amps intermittently.

Foam trays, flexicords and accessory sockets are available separately.

Your Carricell is set at the correct temperature and no further adjustment should be necessary. The heating unit and electronic monitoring components are sealed for protection. In the event of a malfunction please return the unit to your agent or supplier

We hope you will find your Carricell convenient, reliable and a pleasure to use.

John & Judy Dobson